China Manual Paint Dispenser manufacturers - Select 2019 high quality Manual Paint Dispenser products in best price from certified Chinese Colour Paint manufacturers, Waterproof Paint suppliers, wholesalers and factory on Made-in-China.com, page 2. Alibaba.com offers 886 manual paint colorant dispenser products. About 80% of these are mixing equipment, 7% are other chemical equipment, and 1% are furniture paint. A wide variety of manual paint colorant dispenser options are available to you, such as agitator, paddle, and homogenizer.
Page 12: Weekly maintenance, General maintenance, If a col, It is
Advertising
10
15
HARBIL DUAL PUMP COWR DISPENSER
MAINTENANCE
1. DAILY MAINTENANCE
Agitate the colorants as required every morning. The actual amount of agitation
time can be determined by your own experience with the colorants. On dispensers
equipped with manual agitation this would normally be about ten to fifteen turns of the agitator knob every morning, although this may vary from colorant to colorant. Dispensers equipped with motorized agitation would normally be run for approximately fifteen to thirty minutes.
Check the level of the colorant in all of the canisters and if the colorant level is
down to one-half of the lower agitation blade, add a minimum of two quarts of
colorant. The correct operating amount of colorant in each canister should be from one-half quart to six quarts.
Wipe all of the nozzles clean with either water or mineral spirits, depending on
the type of colorant being used (DO NOT USE MINERAL SPIRITS FOR
WATER OR GLYCOL BASED COLORANTS, as this will cause damage to the O-Rings on the Valve Assembly).
2. WEEKLY MAINTENANCE
Dispense a full measure of any colorant that has not been used during the week
into an empty receptacle and then pour it back into the canister (as described in
GENERAL INSTRUCTIONS-Section 5, AGITATING THE COLORANTS on page 8).
3. GENERAL MAINTENANCE
IMPORTANT:
If the dispense nozzle of the pump should become clogged the insertion of a paper
clip or other similar object will clean out any obstruction in the nozzle. However,
before doing this, the DISPENSING VALVE LEVER MUST BE OPENED (pulled forward) as in dispensing. BE SURE TO REMOVE the paper clip before closing the valve lever.
If a col
orant leak develops at the top of the dispensing pump or there is colorant
on the piston rod, a one ounce or five ounce Pump Repair Kit (part no. 4223112
and 4223502 respectively) should correct the problem. If after replacement of the Pump Repair Kit the problem still persists, the inside walls of the pump tube may be scored and the pump tube will have to be replaced.
It is
recommended that one or two pump repair kits be kept in stock for
emergencies.
DUAL PUMP 192 OZ. CANISTER PUMP ASSEMBLY
ITEM
PART NO.
DESCRIPTION
NO. REQ.
4209000
Canister Pump Assy. w/o Agitator & Cover.192 oz. U.S.
1
4209002
Canister Pump Assy. w/o Agitator & Cover.192 oz. Metric
1
4209003
Canister Pump Assy. w/o Agitator & Cover.192 oz. Imp.
1
4209060
Canister Pump Assy. w/o Agitator & Cover.192 oz. U.S.
1
6MM Exit Port
4219000
Canister Block & Sleeve Only,192 oz.
1
4219060
Canister Block & Sleeve Only.192 oz., 6MM Exit Port
1
4000008
Knob, Black, #25.5/16-24 TH
1
2
4228501
Knob, Black.#44.3/8-16 TH
1
3
4000018
Screw, Set, 8-32 x 3/16, Socket, C/P
5
4
4226-
Gauge Assembly Complete.1 oz.
1
5
42265-
Gauge Assembly Complete.5 oz.
1
6
4228100
Gasket, Pump Tube.1 oz.
1
7
4228502
Gasket, Pump Tube.5 oz.
1
8
4235004
Lever. Valve, 5 oz.
1
9
4235005
Pin, Roll, 1/8 x 1-1/2, SS
1
10
4235000
Valve, Lever Assembly Complete, 5 oz.
1
10
4235601
Valve, Lever Assembly Complete.5 oz. (6MM)
1
10
4235501
Valve & O' Ring Assembly.5 oz. (Viton)
1
![]()
10
4235507
Valve & O' Ring Assembly.5 oz. (Thiokol)
1
11
4235006
O' Ring, Valve, Viton.5 oz.
2
Macbook pro ios manual download for laptop. 11
4235007
O' Ring, Valve, Thiokol, 5 oz.
2
12
4000061
Screw, PHCS.10-24 x 3/8 Slot, C/Z
1
13
4235013
Retainer, Valve, Lever. 5 oz.
1
14
4235011
Plunger Valve Stop
1
15
4000150
Nut, Hex.1/4-28.Jam
1
4000108
Nozzle, Cap and Pad
1
Kits
4290502
Kit. Canister Repair.5 oz.
• U.S.
4223502
Kit.Pump Repair.5 oz
•• U.S.
4223112
Kit.Pump Repair.1 oz
•• U.S.
4235014
Kit. Valve Repair.5 oz
.• Single Exit
4235015
Kit. Valve Repair.5 oz
.• Double Exit
Advertising
Popular Brands
Popular manuals
Page 7: Dual pump color dispenser, A. measuring the one ounce dispensing pump, Return the valve lever to the closed (up) position
Advertising
ITEM
PART NO.
DESCRIPTION
NO.REO.
4419000
Cover, Manual Assembly. 192 oz.
1
1
4419005
Cap, Knob.192 oz.
1
4419004
Knob, Crank.192 oz.
1
3
4000063
Pin, Roll,1/8 x 3/4..SS
1
4
4419002
Crank, Manual, w/Knob.192 oz.
1
4
4419006
Crank, Manual. Only.192 oz.
1
5
4430002
Connector, Agitator. 5/16.. w/Screw
1
6
4419001
Cover, Canister, Manual Only
1
7
4000028
Screw. Set.10-32 x 1/4..Slot, SS
1
8
4418007
Pin, Dowell.1/8 x 3/8..Steel
2
DUAL PUMP 192 OZ.
COVER, MANUAL ASSEMBLY
GENERAL INSTRUCTIONS
4. MEASURING AND DISPENSING THE COLORANT
The
Dual Pump Color Dispenser
has a one ounce and a five ounce capacity
dispensing pump on each canister.
The one ounce capacity dispensing pump is equipped with a gauge assembly
calibrated· for the colorant system designated by the purchaser and is used when dispensing into base paint containers of one gallon size or less.
The five ounce capacity dispensing pump is equipped with a dual calibration
gauge assembly. The right side of the gauge assembly is calibrated in the same
incrementation as the gauge assembly on the one ounce pump. The same formula that is used to dispense from the one ounce pump into one gallon containers can be used to dispense from the five ounce pump into five gallon containers, without requiring formula conversion. The left side of the gauge assembly is calibrated in true volume increments from one-eighth ounce to five ounces and is used for dispensing large amounts of colorant.
A. MEASURING THE ONE OUNCE DISPENSING PUMP
Tum the pump gauge to the right to disengage it from the indicator
pointer. Raise the pump gauge so that the indicator is opposite the notch on the gauge corresponding to the amount of colorant to
be
dispensed.
Then turn the handle to the left and move the indicator into the desired
notch. If the colorant is heavy-bodied, allow a few seconds for the colorant to completely fill the pump.
Open the dispensing valve by pulling the valve lever forward to the one
ounce pump dispensing position (see illustration on page 7) until a
positive stop is felt.
With the valve lever open, tum the pump gauge to the right to disengage
it from the indicator pointer and depress fully.
Return the valve lever to the closed (up) position.
20
5
![]()
Advertising
Harbil Paint Colorant Dispenser Parts
Popular Brands
Manual Colorant Dispenser
Popular manuals
Comments are closed.
|
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |